Equipment for creating dispatch communications systems

Composition


Commutator based on M60 multiplexor

GS-03 board

In basic complete the board provides connection of 4 E1 streams and up to 128 subscriber lines and/or junction lines and also cross-connection of 64 rb/s channels within 4 E1 streams.

LT-05 board

The board provides receiving/transmitting of 4 E1 streams and/or Ethernet 100Base-TÕ packets over symmetrical cable pairs at 11,2 MB/s rate over each pair and it has up to 8 G.SHDSL.bis interfaces. It supports tonal dialing. It has full set of dispatch communications functions. It can be the only commutator in dispatch communications system.

AS-05 board

8 channels with FXO terminations.

AK-05 board

8 channel with FXS terminations.

SV-03 board

Eight 4/6-wires TFC channels of E&M type with software adjustment of reception/transmission levels within from minus 20 to plus 20 dB.

IP-08 board

Power supply from the source of DC with (36…72 V).

Subscriber equipment

VK-02 unit

Line commutator in leak-proof housing. It contains FXS and Ethernet 10/100 BaseT/TXinterfaces and FTC outputs to loudspeakers. For the operation at least one commutator with full set of dispatch communications functions is necessary. The unit has two G.SHDSL.bis interfaces for TFC connection, two subscriber FXS interfaces, 100 BaseTX interface for connection to Ethernet network, two interfaces for connecting external loudspeakers of power up to 20 W. Power supply is provided by mains 220 VAC. Working ambient temperature is from minus 40 to plus 50°Ñ

M30AE unit

M30AE unit is designed for connection subscriber equipment to analog ports in the case of creating dispatch communications systems using as commutators KM-14 boards (units) or LT-05 boards which have no analog terminations.

UL-01 unit

The unit is used as loud announcements device. Power supply is provided from mains 220 VAC 50 Hz. In the cases of power interruptions power supply is provided by built-in leak-proof battery for 5 hours of autonomous operation. Loudspeaker with 100 V power supply voltage and up to 6 W power can be connected to the unit.

UL-02 unit2

Similar to UL-01 unit, but it has built-in loudspeaker and has no UPS.

Auxiliary equipment

KBP-03 unit

UPS set KBP-03 is designed for nominal DC 48 V power supply in the cases of absence of mains 220 VAC


ââåðõ